We adopted this as the new standard finish - replacing the previous polished look of our turntables.
One of the added benefits is that you won't see fingerprints, which have a sneaky habit of finding their way onto the controller top plate.
Apart from our platters, all aluminum parts that aren't painted (i.e. Stelvio custom finishes) will be delivered with this new finish.
Related Posts
Savoie Drive PrototypeShown here is the prototype assembly we rigged up for our upcoming Savoie drive system. The new drive implements a much more robust (and larger) motor. To prototype this, we had to house the drive electronics in an external case as shown in the photo. In the past few months, we began to field questions from
Read More5-pin DIN ConnectorThat, is the question … For years, we bought into the common knowledge that tonearms wired with a straight run from the cartridge clips to the connectors (RCA or XLR) are superior to arms with plug-in cables employing a 5-pin DIN connector. Then, we put the theory to the test. The ExperimentWe compared two 4Point, 11″
Read MoreCompleted AssemblyOK, so you accept the premise that cables break in over time by just playing your hi-fi, and that a burn-in device is an unnecessary indulgence. Fair enough. Have you taken into consideration whether the millivolt level voltage output by a moving coil cartridge will ever break in a tonearm and its interconnect … in your
Read MoreShockingIt’s that time of year, when we’re fielding questions about static build-up on turntables … well, non-Galibier turntables that is. On our Galibiers, static is a non-problem as you’ll see below, but with other turntables the solution may not be “built in”. We have 2 approaches to solving this. In this post, we addressed a possible work-around to
Read MoreNever miss a good story!
Subscribe to our newsletter to receive a copy of a setup report we created for a customer.
Subscribers also receive discounts on all accessories, including Audiodesk, Feickert and AnalogMagik.
This report is in 3 sections:
15 pages packed with general setup information - tricks you may not have seen before
Documentation of the customer's setup
A tool guide - how to specify a USB microscope and build your own azimuth gauge
Click the photo below, to subscribe.