Savoie Drive Calibration
Calibration jig for our Savoie drive system. Oscilloscope not shown.
Read More(click to enlarge)
This is part 3 of our NiWatt build log (installment #2 is here). We're nearing the finish line with about 3 hours' work remaining for each amplifier.
The observant reader will note that this is a photo of the right ampifier (note the binding post and output transformer location on the left side of the photo). In part-2, we photographed the left amplifier. They are mirror imaged to minimize the length of cable runs.
This phase completes the power supply section as well as the binding posts and output transformer wiring.
Remaining tasks address the "front" of the amp (the main board with the signal circuit and power supply filtering) along with installing the filament wires to the signal tubes.
Wiring the binding posts would appear to be a trivial task, but these Cardas posts are heat sinks and take quite a bit of time to get the solder to flow.
There are several other good candidates - low mass posts in particular. The downside to these posts is their fragility.
The last thing we want is for an amplfier to be shipped to us because someone has overtightened a binding post. It happens!
Shown in the center of this photo is the copper pipe which serves as a shield for stray AC from the filmament and power switch wiring.
Reflecting on this journey, here's a link to a post from 9 years ago where we laid out our key design goals. At the end of this post is a link to one where we document the early breadboarding process.
Stay tuned for the final installment.
(click to enlarge)
Related Posts
NiWatt Amplifier Build – Part 3
(click to enlarge)This is part 3 of our NiWatt build log (installment #2 is here). We’re nearing the finish line with about 3 hours’ work remaining for each amplifier. The observant reader will note that this is a photo of the right ampifier (note the binding post and output transformer location on the left side of
Read MoreNiWatt Amplifier Build – Part 2
NiWatt Build in Progress (click to enlarge)Part 2 of our NiWatt build log (installment #1 is here). At this point, in the build, about 7 hours’ work remains for each amplifier. Shown here are the glass/fiber epoxy boards after “staking” the turrets: 3 boards for each amplifier. Preparing boards to the point shown here
Read MoreA Pass Labs XA-25 Demo With Rockport Speakers
(click to enlarge)We just demo’d a Pass Labs XA-25 amplifier at a customer’s house. The amplifier showed its pedigree, with all of the clarity, delicacy and nuance you’d expect from a Pass Labs design. At the same time, the Rockport speakers showed how power hungry they are. While the amps never sounded stressed (up to sane, but loud
Read More