Really, Koetsu?
Why does a $15,000 cartridge have a $0.10 stylus guard?
The cynical amongst us would conclude that it's to increase rebuild sales.
I don't subscribe to conspiracy theories in general. The answers are typically found in neglect or oversight (but don't get me started on airplanes falling out of the sky).
I'm more interested in mitigating bad outcomes, however I can. Of course, root cause analysis is essential to long term improvements.
I don't mean to single them out. There are many fine manufacturers who think of stylus guards as an afterthought. They say that a conclusion is the point you reach when you get tired of thinking.
One brand (with an "X" and a "V" in their model name) has a "guard" that presents more risk to cantilever health than leaving it naked to the wind would.
How many "my cleaning lady did it" stories have I heard?
Shipping a mounted cartridge (we do remote setups when possible) presents an even greater problem.
At the other extreme (and to their credit), Lyra's guards are beautifully designed, complete with rails that mate into milled grooves in the cartridge body.
Another beautifully engineered stylus guard is found on all of Kuzma's cartridges.
They're machined aluminum and they screw on to the cartridge body. You could put one in your pocket along with some loose change.
I'd be remiss if I didn't mention that these cartridges are also very fine, and worthy of the Kuzma name.
Ask us about them.
Kuzma Screw-on Stylus Guard
Secure and Ready for its Journey
Off to the workshop, we fabricate headshell carriers for our customers when the situation dictates it.
Beautiful they're not, but we never claimed to be cabinet makers.
A snapped cantilever is a whole lot uglier.
If you're interested in the delivery report we created for this customer's setup, email us.
Related Posts
5-pin DIN ConnectorThat, is the question … For years, we bought into the common knowledge that tonearms wired with a straight run from the cartridge clips to the connectors (RCA or XLR) are superior to arms with plug-in cables employing a 5-pin DIN connector. Then, we put the theory to the test. The ExperimentWe compared two 4Point, 11″
Read MoreWind RiverCan we talk? Quite some time ago, we published photos of a well-maintained stylus, and followed up with a post describing various stylus cleaning methods. It’s time to have a serious conversation about our connectors …Audio HygieneMaintaining a high-performing audio system requires a minimal amount of work, and one chore involves periodically cleaning and re-treating our
Read MoreCompleted AssemblyOK, so you accept the premise that cables break in over time by just playing your hi-fi, and that a burn-in device is an unnecessary indulgence. Fair enough. Have you taken into consideration whether the millivolt level voltage output by a moving coil cartridge will ever break in a tonearm and its interconnect … in your
Read MoreShockingIt’s that time of year, when we’re fielding questions about static build-up on turntables … well, non-Galibier turntables that is. On our Galibiers, static is a non-problem as you’ll see below, but with other turntables the solution may not be “built in”. We have 2 approaches to solving this. In this post, we addressed a possible work-around to
Read MoreNever miss a good story!
Subscribe to our newsletter to receive a copy of a setup report we created for a customer.
Subscribers also receive discounts on all accessories, including Audiodesk, Feickert and AnalogMagik.
This report is in 3 sections:
15 pages packed with general setup information - tricks you may not have seen before
Documentation of the customer's setup
A tool guide - how to specify a USB microscope and build your own azimuth gauge
Click the photo below, to subscribe.