Shocking
It's that time of year, when we're fielding questions about static build-up on turntables ... well, non-Galibier turntables that is.
On our Galibiers, static is a non-problem as you'll see below, but with other turntables the solution may not be "built in".
We have 2 approaches to solving this.
In this post, we addressed a possible work-around to adapt our static draining solution to turntables from some other manufacturers.
A humidifier. If you can reach an indoor humidity of 35 to 40%, your problem should be solved.
Here in Colorado, the indoor Winter humidity can drop to 10-15% during cold snaps, but since we began humidifying, we no longer generate static sparks when touching the ground screw on a light switch.
Try it. Your sinuses will thank you.
The short story is that our bearings are grounded which forms a static drain.
With the ground wire terminated to your phono stage (or the ground screw on a wall outlet), the static jumps the capacitive barrier (the oil) between the bearing spindle and body and this prevents build-up.
The above blog post documents a work-around we developed to implement this completely reversable solution for some other turntables.
It's not always possible to find a spot on many bearings, but don't blame us ;-)
If your problem occurs only during the dry, cold, Winter months, then there's a solution that's not only good for your turntable, also for your sinus passages: a humidifier.
Bearing Ground Wire Attachment
Related Posts
click to expandWith apologies to Wayne Gretzky …Wayne Gretzky was quoted as saying: “you miss 100% of the shots you don’t take”. With respect to cleaning machines, the best machine is the machine you actually use.I’m reminded of cameras, where a similar rule applies: it doesn’t matter how good your camera is if your rig is
Read More(click to enlarge)Shipping a mounted Van den Hul …Preparing a mounted Van den Hul cartridge for shipping is not for the faint of heart.We recently prepared a Van den Hul Colibri XGW Signature Stradivarius, and these photos are the result.In a perfect world, cartridges would have stylus guards that actually work, but other design considerations
Read More5-pin DIN ConnectorThat, is the question … For years, we bought into the common knowledge that tonearms wired with a straight run from the cartridge clips to the connectors (RCA or XLR) are superior to arms with plug-in cables employing a 5-pin DIN connector. Then, we put the theory to the test. The ExperimentWe compared two 4Point, 11″
Read MoreWind RiverCan we talk? Quite some time ago, we published photos of a well-maintained stylus, and followed up with a post describing various stylus cleaning methods. It’s time to have a serious conversation about our connectors …Audio HygieneMaintaining a high-performing audio system requires a minimal amount of work, and one chore involves periodically cleaning and re-treating our
Read MoreNever miss a good story!
Subscribe to our newsletter to receive a sample setup report we created for a customer.
Subscribers also receive discounts on all accessories, including Audiodesk, Feickert and AnalogMagik.
This report is in 3 sections:
Documentation of the customers's setup and QC
30 pages packed with general setup information - tricks you may not have seen before
An appendix with a guide to tools and other setup tips, including how build your own azimuth gauge
Click the photo below, to subscribe.