click to expand
Every element of Kuzma's tonearm designs takes rigidity and energy transfer into consideration, so it should come as no surprise that this applies to their headshells.
In the photo (click to expand), take note of the longitudinal reinforcing ribs.
While they add rigidity, the narrow spacing presents a minor challenge, if you want to place washers underneath the mounting screws.
It's a minor point, but washers present a smoother surface for sliding the cartridge when making make fine adjustments during setup - especially when tuning zenith.
Note that for setup purposes, we've recently adopted nylon washers which slide even more easily.
After completing the setup, we'll audition washer materials for sonics. It's a simple matter to swap the brass washers back after dialing in the geometry (hint: remove/replace the mounting screws one at a time to preserve the geometry).
While the correct diameter washers are too wide to fit in the channels between the reinforcing ribs, the solution is simple: file flat spots on the washers. We prefer this solution to smaller diameter washers which of necessity, have barely more contact area than the socket head screw's diameter.
The easiest way to modify them is to hold the washers in either a bench top vice or a pair of Vice Grip pliers, and file the flats.
Simple ... no?
There's much to be said about washers, but in general, we've found brass and stainless to be our preferred materials. Experimenting with Nylon is worthwhile however.
The Schröder CB is an exception. It responds very well to nylon's compliant interface - allowing you to tune dynamics much more precisely.
Suffice to say, that if you employ washers, pay attention to their material and see what works for you, in your system. Some tonearm designs may have a different approach to energy management.
Related Posts
click to expandWith apologies to Wayne Gretzky …Wayne Gretzky was quoted as saying: “you miss 100% of the shots you don’t take”. With respect to cleaning machines, the best machine is the machine you actually use.I’m reminded of cameras, where a similar rule applies: it doesn’t matter how good your camera is if your rig is
Read More(click to enlarge)Shipping a mounted Van den Hul …Preparing a mounted Van den Hul cartridge for shipping is not for the faint of heart.We recently prepared a Van den Hul Colibri XGW Signature Stradivarius, and these photos are the result.In a perfect world, cartridges would have stylus guards that actually work, but other design considerations
Read More5-pin DIN ConnectorThat, is the question … For years, we bought into the common knowledge that tonearms wired with a straight run from the cartridge clips to the connectors (RCA or XLR) are superior to arms with plug-in cables employing a 5-pin DIN connector. Then, we put the theory to the test. The ExperimentWe compared two 4Point, 11″
Read MoreWind RiverCan we talk? Quite some time ago, we published photos of a well-maintained stylus, and followed up with a post describing various stylus cleaning methods. It’s time to have a serious conversation about our connectors …Audio HygieneMaintaining a high-performing audio system requires a minimal amount of work, and one chore involves periodically cleaning and re-treating our
Read MoreNever miss a good story!
Subscribe to our newsletter to receive a sample setup report we created for a customer.
Subscribers also receive discounts on all accessories, including Audiodesk, Feickert and AnalogMagik.
This report is in 3 sections:
Documentation of the customers's setup and QC
30 pages packed with general setup information - tricks you may not have seen before
An appendix with a guide to tools and other setup tips, including how build your own azimuth gauge
Click the photo below, to subscribe.